MIL-PRF-44015A(GL)
3.3.4 Interchangeability. Component parts of the
refrigerator-container, which are replaceable, shall be
interchangeable with the same parts of other containers furnished
under the same contract.
3.4 Support or ownership requirements. The container units
shall meet the following support or ownership requirements.
3.4.1 Weight.
The weight of the container shall not exceed
3500 pounds.
3.4.2 Structural requirements. The containers shall be
structurally suitable for conveyance by road, rail and sea,
including interchange between these forms of transport.
3.4.3 Corner fittings. The container shall have corner
fittings located on all eight corners.
The corner fittings shall conform to the dimensional and strength
requirements of ISO 1161 and shall withstand all structural
testing requirements herein.
3.4.4 Spacer block and coupler. Unless otherwise specified
(see 6.2) one spacer block and one coupler shall be provided with
the container. Two couplers shall be of sufficient strength to
allow for the connection of the bottom end corner fittings of two
containers. The spacer blocks shall maintain a 3-inch space
between the containers when attached to the upper end corner
fittings. A storage bracket for the spacer block and coupler
shall be provided in the exterior refrigeration unit area of the
container.
3.4.5 Forklift pockets. The container shall have forklift
pockets conforming to the requirements of ISO 1496-2.
3.4.6 Tie-downs. The two interior side walls shall each have
two recessed cargo tie-down rings located as shown in figure 1.
3.4.7 Shelving. Four individual sets of shelving shall be
provided. Each shelving set shall be 42 inches long by 18 to 20
inches deep and 58 to 66 inches high with four shelves in each
set adjustable in no less than 2-inch increments without the use
of hand tools. Each individual shelf shall be capable of
supporting the concentrated loads of 200 pounds during use
without permanent deformation or distortion. Shelving shall
comply with the applicable requirements of NSF Standard No. 2.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business