MIL-PRF-44015A(GL)
3.2 Operating requirements. The container units shall
satisfy the following functional, operational and performance
requirements.
3.2.1 Heat leakage. Heat infiltration or loss through the
container shall be minimized.
3.2.2 Air leakage.
Air leakage of the container shall be
minimized.
3.2.3 Safety. The container units shall minimize
flammability, operational, toxic and personnel hazards.
3.2.4 Drainage. The container shall have floor drains which
provide complete and total drainage of the container. The drains
shall open automatically when subjected to pressures above normal
internal pressure. The drains shall be provided with manual
closures. The drain openings shall be recessed below the bottom
surface of the floor.
3.2.5 Door. The door shall be flush with the container
exterior when closed. The door shall be provided with a means to
prevent door hardware from damaging the exterior container skin
when opened. The door opening shall be a minimum of 74 inches in
height and 36 inches in width. External hardware shall be
protected from damage and not extend beyond corner fittings.
Means shall be provided to hold the doors in the full open
position. The door shall open outward from the right.
3.2.6 Door handle and latch. The door shall have an external
handle which shall operate a heavy duty locking device which
shall securely hold the door in the closed position during all
modes of shipment and rough handling. The latch shall have
provisions to accept a padlock as specified in 3.3.3. With the
padlock in place, the door shall be incapable of being opened
from the outside. The door shall have an internal release handle
to allow the door to open from the inside to permit a person in
the container to exit when the container is padlocked on the
outside. The handle and latch shall be protected from damage
during shipping. The handle and latch shall not extend beyond
the corner fittings.
3.2.7 Interior light. The container shall have a vapor proof
lighting fixture mounted on the interior and a recessed or
protected vapor proof switch located near door on the exterior of
container. The fixture shall have a protective cover which is
shatterproof and removable without tools for bulb replacement.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business